pandamove6

Fiat 500 Replacement Key Fob It's possible to replace the battery if your 500 remote key fob isn't working. If you replace the battery, but it isn't working it could be a problem elsewhere. United Locksmith specializes in the production of new keys for classic vehicles. We have the tools as well as the parts needed for this job. Dead Coin Battery The most common reason your Fiat 500 key fob will not lock or unlock the doors is due to a dead battery. The coin cell battery in the key fob can be depleted quickly in the event that you don't use it often enough. If your remote began to show signs of weakening such as a loss in range, and then stopped working completely the battery could be dead. Metal clips keep the battery in on the key fob. If the clips aren't tight enough, it can cause problems with contact, which can prevent your remote from receiving power. Use key for fiat 500 TheKeyLab remove the retaining clip and then remove the old battery. Use a battery that has the same voltage, size and specification as the original. The key fob may be damaged or corroded by exposure to water. Even a short bath in soapy water could harm the electronic chip in. Keep your key fob dry. Water Damage Water damage could be the cause of your key fob's not functioning properly. The rubber seals on key fobs stop them from getting damaged by a light drizzle or splash of water. However, it is essential to keep the car keys away from the washing machine, the ocean and pool. The key fob contains an electronic chip that transmits a message to the immobilizer of your car. This is the reason why your 500 can start or lock, however should the chip become wet, it will no longer work. If you're trying to determine if your key fob is still working you can clean the internal electronics using isopropyl or electronic cleaner. However, it is probably better to purchase a replacement from a dealership instead of trying to repair the key fob which has been submerged by salt water. While a replacement fob can cost you a bit of money, it's much less expensive than paying for your Fiat 500 to be towed to a dealership and fixed! You can also make it yourself with a few simple steps. Be sure to have the correct battery type before attempting to open your keyfob. This is a job that's far simpler than it appears and there are step-by-step instructions online for almost any key fob for cars. Faulty Chip The chip that is contained in the key fob communicates to your car's immobiliser unit to ensure the car is able to start when the correct key is used. If the chip is damaged or corrupted the car won't start, no matter what you do. A chip that is defective can happen due to many reasons, but most commonly due to water damage or the battery being dead. Regardless of the reason, it's best to delegate the job to a locksmith, as they will be able to repair the chip fast and at a low cost. If your key fob stops functioning after exposure to clean water from the tap or rain, remove the battery and clean the electronic component using a paper towel to ensure it's dry before putting it back into. If the key fob still does not work, it is likely to be a damaged chip and is required to be replaced. A few people turn to their dealer when they are in need of an entirely new Fiat key fob, however this can be a very costly option. If you are seeking a cost-effective solution to get your Fiat key fob fixed Look no further than United Locksmith. We have the tools and experience necessary to fix your Fiat key fob in a timely and professional manner. Faulty Receiver Module Fiat key fobs send signals up 50 feet away to the vehicle, which will open and lock the doors (and start the vehicle for vehicles with automatic transmissions). However there are a few factors that can cause the fob to stop working. This could be due to a dead battery, water damage, worn-out buttons an issue with the receiver, signal interference or an issue with the chip. If the fob is in the pocket of someone who has suffered extreme trauma (such as being dropped onto a hard floor or being washed in the washing machine) it might not be in a position to connect with the Body Control Module (BCM) of the vehicle. This is because the BCM is a secure system that can only accept signals from a genuine original key and not any other. You'll have to replace the fob in case this occurs. A locksmith professional can handle all aspects of the key replacement process and even program a new one for your 500. In fact, they can provide you with a duplicate key that functions exactly the same as your original fob (and costs only a fraction of the cost).